The eLearning Center for Gatlin Education Services

Too much current flowing through an electric circuit can damage the circuit and create a safety hazard. How much current is "too much current"? That depends on the circuit and its components. For some circuits, 1 ampere would be too much current, while for other circuits 1 ampere would be perfectly acceptable. Circuit protection devices protect electrical equipment by rapidly disconnecting power to components in the event of abnormal overload conditions resulting from excessive voltages, ground faults, and accidental shorting of a circuit.

Two types of circuit protection devices are common; fuses and circuit breakers both operate by opening and interrupting current to the circuit. A fuse or circuit breaker is designed to create an open circuit if too much current flows through it. You can think of it as a switch that automatically turns itself off if the current through it exceeds a certain level. When a fuse is "blown" by having too much current pass through it, the fuse is ruined and must be replaced. On the other hand, when a circuit breaker is "tripped" by excessive current, the circuit breaker can be reset and used again, instead of being discarded. The choice of which to use depends on the specific application, circuit type, its electrical specifications, space available, environmental constraints, and customer preference. In the US, the National Electric Code (NEC) exists to guide electricians in the proper installation of electrical equipment and defines the specific requirements for circuit protection. In Canada the Canadian Electric Code (CEC) exists to provide similar guidance. Other areas of the world have equivalent country or local codes.

A proper circuit protection strategy reduces long-term maintenance needs and other costs, and minimizes system downtime. This 3-hr course provides an overview of circuit protection devices and is based entirely on Naval Education and Training Materials (NAVEDTRA 14175), Electricity and Electronic Training Series; Module-3 and covers Chapter 2 titled “Circuit Protection Devices”.

The student must take a multiple-choice quiz consisting of fifteen (15) questions at the end of this course to obtain PDH credits.

State Board Acceptance

This course can be used by professional engineers to fulfill PDH requirements mandated by state and provincial licensing boards. Decatur Professional Development is an approved provider of continuing education in all states that pre-approve course providers. In all other states that mandate continuing education for engineers, it is the individual engineer's responsibility to determine the suitability of activities for PDH credit. The state boards typically accept online* courses that cover technical, managerial** or ethical content and which are relevant to the practice of engineering. The course must have a clear purpose or objective with a content that will maintain, improve or expand the skills and knowledge of the licensee's field of practice. For questions about your mandatory PDH requirements, visit the website of your state licensing board.

*Online courses are accepted by all state licensing boards that mandate continuing education. Other than New York (which limits online courses to 18 PDH) and Iowa (which limits online courses to 6 PDH), there are no limits placed by other states on the number of hours that can be earned through online continuing education. Consult with your state licensing board if you have any questions about the acceptability of online courses.

**The New York State Board of Engineers does not accept general office management courses, but will accept project management courses that are offered by an approved provider and that are technical in nature and contribute to the engineer's professional practice.

Please Note: Continuing Education credits for this course are awarded as PDH (Professional Development Hour Credits).